HYDRO Colour stain BC (colour tone) for spraying and wiping off

Hesse Colour stain BC is a pure pigment stain for achieving transparent to opaque staining. The specially selected pigments enable high brilliance and transparency. The wood’s structure is more or less strongly covered depending on colour tone depth. Colour tones can therefore be achieved which are even lighter that the inherent wood colour. The light fastness of Colour stains represents the maximum achievable among all stains. Covering colour tones can be achieved, per RAL, Sikkens or NCS colour charts for example. The colour tone to be achieved depends on the type of wood.

Enquire article

Page content

Product features

Areas of application

Technical information

Sustainability data sheet

Technical Specifications

Processing Instructions

Highlights

Can be used on many woods
All tones can be mixed with each other
Spraying with wiping
Use for tones uncommon in wood, for instance according to RAL

Processing

Airmix
Compressed air spraying
Spreading
Airless low pressure
Wiping with a cloth
other treatment

97%sustainable

water 87%
renewable resources 1%
mineral resources 9%
fossil resources 3%

Areas of application

For staining with subsequent over-painting in industry and handcrafting of furniture, stairs and doors.

Technical information

PDF

HYDRO Colour stain BC (colour tone) for spraying and wiping off 1 MB

Sustainability data sheet

PDF

HYDRO Colour stain BC (colour tone) for spraying and wiping off 487 KB

Technical Specifications

Appearance	glazing
Number of layers (max)	1
Quantity per layers (min)	30 g/m²
Quantity per layers (max)	80 g/m²
Total quantity applied	80 g/m²

Processing Instructions

Drying	3 h / 20 °C
Surface sanding (grain size)	120 - 180
Intermediate sanding (grain size)
Yield per pass	13 - 34 m²/l
Processing information	Spray a copious coat of the HYDRO Stain in one pass using a cup gun (1.5 - 2 mm nozzle, circa 2 bar spray pressure). Allow a brief penetration time and distribute the excess using a broad spreading brush, working first across and then with the grain. Intermittently wipe stain absorbed by the spreading brush onto a rag.It is advisable to use two people to wipe large surfaces. A uniform application method and the same advance sanding are essential to prevent colour tone differences. Application via brush or sponge is also possible instead of the spraying process.
Special notes	Hesse stains are matched to each type of wood in terms of colour tone and processing. Further application methods are possible. All stains from the same range can be mixed with one another. Lighten by adding water. Can be tinted with colour concentrates in the range: BP 30xx and BP 3570 NEW.In wood types with a high proportion of water-soluble wood constituents (e.g. oak), discolouration may occur when using aqueous products. We therefore recommend clear insulation with HYPERION TI 130, especially for pastel or white colour tones.Spraying with wiping is used in preference on coarse-pored woods like oak, ash or mahogany. The copious excess and its subsequent incorporation by means of wiping with a brush provides better wetting of the pores.

General Notes / Disclaimer

Our technical information is continually adapted to keep up to date with the latest technology and statutory regulations. The latest version is always available online at www.hesse-lignal.de or talk to your local account manager. This information is for advice and is based on the best knowledge available and careful research in line with the current state of the art. This information cannot be held as legally binding. We also refer you to our terms and conditions of business. Safety data sheet is provided in accordance with EC regulation no. 1907/2006.