Sanded metallic

• Substrate material: milled, foiled chipboard or MDF board, treated with filler and milled
• Prime with 1 x 150 - 200 g/m² PU Isolating filler DP 491-9343, mixing ratio (by volume) 4 : 1 with PU Hardener DR 405 and as necessary with the addition of 10% Thinner DV 490
• Allow to dry for at least 16 h / 20 °C
• Sand in one direction using 80 - 180 grit according to the effect desired
• Finish with 1 x 80 - 120 g/m² PU Sanded Metallic DB 46777-M0790 silver, applying from both sides along the sanding direction, mixing ratio 10 : 1 with PU Hardener DR 4070 and as necessary add 5 - 10 % Thinner DV 490
• Optionally finish with either UNA-PUR DE 559 glossy or DE 554 semi-matt after a maximum of 2 h, without sanding, mixing ratio 10 : 1 with PU Hardener DR 4070
• Dry for at least 16 h / 20 °C room temperature

Please observe the latest technical information and the material safety data sheets for the stated individual products. 
Please follow the precise specifications for addition of hardeners and thinners.

The effect depends on the selected effect sanding and the application quantity of Metallic lacquer. PU lacquers should not be processed and dried at material/room temperatures below 18 °C. PU lacquered surfaces should be freshly sanded before finishing to avoid adhesion problems. We recommend using a soft duster for normal dry cleaning. Microfibre or leather cloths are suitable for damp cleaning. Dampen the cloth with water, wring it out and damp clean. Harsh household cleaners or abrasive substances are not suitable! Please apply a test coating under real conditions!

This information is purely advisory and is based on the best knowledge available after careful research in line with current state of the art technology. It is not legally binding. We also refer you to our Terms and Conditions. The material safety data sheet according to regulation (EC) No. 1907/2006 is available on request.